This tiny china lady with a bun hair do is very choice.
And the little red hen said....
A nice group of chinas all with covered wagon style hair do's
I hope to get a nice large china done before I quit for this round. It already feels so good to have these pretty far along. E
I had an email a little while ago about this post and here is my answer to it:
Hello Pat, Thank you for writing, nice to hear from
you. I need to do a tutorial on making
bodies for china and other shoulder heads and put it on YouTube for people to
access easily. I will likely never get to that. I will try to answer a little of your email
here. First I use Morning glory polyfil to stuff the bodies with. There are other good ones and some not so
good.
I like plain Elmer’s glue
to attach the heads. I leave them a full 12 hours sitting up to dry. I place
them on my bathroom vanity on a paper towel in case some excess glue should
drip down. If it does I used too much or
in the wrong place where the china is not snug against the stuffed fabric
torso.. The shoulder head should fit the torso, not
have to be forced down hard over it.
This forcing onto an over full body breaks many a papier mache doll’s
shoulders. When you push on polyfil it
pushes back. Never use sawdust, it will eventually rot the fabric it touches,
and sooner sometimes than you think. Real
cotton is a great stuffing if you are lucky enough to have that. Wool feels nice and works well but draws
insects and you do not know where the doll might be stored later in its existence,
I want to say “life” because they are almost alive to me.
If needed to keep
the head in place, a long strip of bias tape is good to wrap round the doll’s
neck to waist and around and back several times and pin in place til dry. You might keep a piece for this and reuse it.
Be sure to set the head in place well, I
work in front of a big mirror so I do not get it crooked or turned up or down.
I rarely sew through
the sew holes of the china head, and if I do, I pull a small piece of ribbon or
twill tape through the holes in the shoulder head and sew those down to the
front and back of the body. Much better than trying to sew through the holes.
This extra safeguard is good for a very heavy or large head. Put the ribbon or tape in place before gluing
on the head, and sew the tape ends down after all is dry. Of course you can use just the sew holes and
no glue.
I am sorry I do not have a good source of china hands and
feet to recommend. I will be glad to pass along anything sent in by
readers. They are sometimes available at
doll shows. I have a large supply bought
years ago, and I supplement it with porcelain hands and feet from Ebay or RL. I keep boxes of extra doll parts. Often they do not fit the one I bought them
for and I must try again. Be sensitive
to what is and is not a good style for heads of a given era. Look at a lot of all original dolls.
The little china
hands and feet need to be tightly attached. I sew a sleeve/tube large enough to
turn right side out over the piece. I
place for instance a china arm in the sewn sleeve with the wrong side out. On the
end of the china arm, I gather a thread and pull it tight and then wrap it
twice around the arm keeping the thread in the grove it should have, and knot
it. Then I turn the extra fabric back out
of the way and put a tiny line of Elmer’s glue on the end of the china arm.
Pulling the fabric back over this to glue it to that edge gives extra insurance
against loss later. Now turn the fabric
sleeve right side out and voila! An arm read to stuff lightly and sew in place.
The part of the arm or leg closest to
the torso should not have any stuffing, (top of the fabric tube.) This allows them to fold well.
Have a great time
with your growing doll family, Edyth